GHL ProfiLux 4 - Page 41

Instruction Manual ProfiLux 4 / 4e
EN 2019-01-22 41
The connection can be disconnected by pressing the "Disconnect” button in the upper ribbon
bar.
If your ProfiLux is connected to GCC and you make settings directly on your ProfiLux 4 at the
same time, you have to transfer these to the GCC by pressing the "Update view" button.
DANGER
• If you have made or changed settings for your device via the GCC,
you have to save them using the "Save changes" button, before
you disconnect your device. Otherwise your changes will not be
transferred to the device.