36
EOF 10-10/20
4-05. Perform Boil Out Procedure
● Dissemble and thoroughly clean the Filter Pan to remove any dirt or debris that may have accumulated during
shipping, and to remove any oils or residue that may remain from manufacturing processes. See Section 6-02,
Cleaning Filter Pan & Replacing Filter Paper after Boil-Out. NOTE: It is normal for some surface rust to possibly form
on the Hold-down Frame and steel support frame in the Filter Pan during shipment. Typically, any rust can easily be
removed with a wire brush or steel wool. Once the unit is in use, it is unlikely that rust will return.
● Wash all accessory items (Screens, Baskets, Basket Scoop, Brushes, tools, etc.) in warm soapy water and dry
thoroughly.
● Remove any adhesive protective film that may remain on sheet metal surfaces. This has been left on the unit to help
protect the exterior finish during shipment. Clean exterior surfaces with a good quality stainless steel cleaner/polish.
Fryer preparation is now complete; proceed to the Fryer Operation Section.
Perform a Boil Out Procedure on each cook Vat to remove any dirt or debris that may have accumulated during shipping,
and to remove any residue from manufacturing processes. See Section 6-01, Boil Out Procedure. After boil-out is
complete, proceed to Section 4-06.
4-06. Initial Cleaning Before Cooking
Installation Checkout & Prep
To Next Page
Loading...
