GILES EOF10-10 - Cleaning the Filter Pan & Renewing Filter Media

78
Cleaning
EOF 10-10/20
1. With Filter Pan removed from Fryer, remove and clean
Crumb Screen
①, if being used.
2. Use the supplied metal Crumb Scoop to remove as much
of the accumulated filter sediment as possible from the
filter media surface, particularly around the edges. This
will help prevent debris from falling through the perforat-
ed support screen and potentially causing the filter pump
to clog.
3. Remove and clean the Filter Pan Cover
②. Dry
thoroughly.
4. Turn the four Levers
④ to disengage the Hold-down
Frame
⑤. Remove, clean and dry Frame thoroughly.
5. Remove the soiled Filter Media
⑥, either Paper or
Mesh Screen (SSFS).
Paper
: Carefully roll up soiled sheet and discard; avoid
allowing filter debris to fall through the permanent
perforated support screen
⑦ in the Filter Pan bottom.
SSFS Screen
: Remove the screen; avoid allowing filter
debris to fall through the permanent, perforated support
screen
⑦ in the Filter Pan bottom. Using only hot water
and a soft bristle brush, clean Screen in sink. Shake out
water and dry with clean dry towel. Screen must be com-
pletely dry before re-installing in Filter Pan.
DO NOT use soaps or cleaners of any kind for washing
the Filter Screen!
6. Thoroughly clean and dry the Filter Pan ⑧. Flush out
any debris that may have fallen through the perforated
support screen. Be sure to drain all water from the Filter
Pan piping.
6-02. Cleaning the Filter Pan & Renewing Filter Media
5
7
6
8
1
4
This section explains the procedure for cleaning the Filter Pan and refreshing the filter media - either reusable mesh
screen (SSFS) or disposable filter paper. At a minimum, this cleaning should be performed once per day of opera
-
tion, and each time a Boil-Out procedure (Section 6-01) is performed.
Wear thermal protective gear to protect hands from potentially hot parts.
NOTE: Unless otherwise instructed, all parts can be cleaned with
warm soapy water or a mild, biodegradable degreaser, such as Simple
Green®. After cleaning parts should be thoroughly rinsed with clean
water and completely dried.
Filter Paper
or Mesh
Screen
2