69
Fryer Operation
EOF 10-10/20
5-04. Removal of Liquid Shortening (Continued from previous page)
8
9
10
12
If holding the Discharge Hose during the next step, be sure the wear thermal hand protection mitts. Some
parts of the hose assembly can become very hot.
6. Connect the supplied Oil Discharge Hose ⑧ to the Discharge Hose Coupling ⑨.
7. Place the discharge end into an appropriate hot waste oil Disposal Container
⑩ (Giles Oil Caddy is shown)
8. Place the Pump Discharge Valve Handle
⑪, inside the right-hand Cabinet, in the TO DISCHARGE HOSE
position.
9. Place the Pump Switch
⑫ in the ON position. Allow the pump to run until all liquid shortening has been pump
into the waste oil Disposal Container.
10. After all the used oil has been removed from the Filter Pan, return Pump Switch to the OFF position.
11
Continued on Next Page
To Next Page
Loading...
