GME TX6600PRO - Quiet Mode Setup

TX6600PRO INSTRUCTION MANUAL
50
Resending the last SelCall
To make another call to the last sent SelCall contact simply hold the
CALL
LOCK
key. The
radio will transmit the most recently sent SelCall Ident.
Manually Dialling a SelCall Ident
There may be times when you want to send a SelCall to someone without storing
them in your contact list.
1. Press
CALL
LOCK
to enter the CALL Menu.
2. Rotate the Channel knob or press the keys to cycle to the
DIAL option then press
MENU
F
to select.
3. The last sent or received SelCall Ident will be displayed with the right-
hand digit ashing.
4. To send the displayed Ident without changes:
i. Hold the
CALL
LOCK
key. The ident will be sent.
5. To edit the displayed Ident before sending:
i. Rotate the Channel knob or press the keys to select the
desired number in the ashing digit position.
ii. Press
MENU
F
to advance to the next digit position.
iii. Repeat steps i & ii to change any required digits.
iv. When the desired Ident is displayed, hold the
CALL
LOCK
key to send.
Call acknowledge
If your SelCall transmission was successful, the radio you called should respond
with a call-acknowledge transmission which will be heard in your radio as two
quick beeps. This will conrm to you that the radio you called is now alerting its
user to your signal. If the call-acknowledge is not received the other radio may be
out of range or on a dierent channel.