GME TX6600PRO - Group Calling

TX6600PRO INSTRUCTION MANUAL
52
NOTE: The SelCall Alpha/Ident toggle option described above is the default setting
when holding the PRO key. However the PRO key is user programmable and
can be changed. If so, the HOLD function on your PRO key may have a dierent
operation. In this case follow the steps below to switch between the Alpha and
Ident modes.
1. Press
CALL
LOCK
to enter the CALL Menu.
2. Rotate the Channel knob or press the keys to cycle to the
SAVED option then press
MENU
F
to select.
3. While displaying a contact (it doesn’t matter which one), press
MENU
F
to
toggle between the Ident and the Alpha Name. The option you select
will determine how incoming SelCall contacts will be displayed on the
LCD.
4. When nished, press
CALL
LOCK
several times to exit the CALL menu.
NOTE: If an Alpha Name has not been programmed for the incoming contact,
‘– – – – – ’ will be displayed.
Quiet Mode
The QUIET mode mutes the TX6600PRO’s receiver to prevent any incoming signals
from being heard in the speaker until your SelCall Ident is received. This allows you
to monitor a busy channel for personal calls without being disturbed by unwanted
signals.
If your SelCall Ident is received, the QUIET mode is cancelled and all incoming
signals are heard in the speaker.
Setting up the QUIET mode
To setup the QUIET mode you must rst ‘tag’ the channels that you want to stay
Quiet. You can then activate the QUIET mode and only the channels you have
tagged will remain Quiet to incoming signals (unless your SelCall Ident is received).
Channels that were not tagged will remain open to all signals and will continue to
operate normally.
To tag or un-tag a channel for QUIET operation
1. Rotate the Channel knob or press the keys to select the
desired channel.
2. If the Q icon is visible to the right of the channel number, the channel
is currently tagged for quiet operation. If the Q icon is not visible, the
channel is not tagged.