Programming Tekna Plus monitors:
PROGRAMMING THE MONITORS
If it is a general entrance door panel in a residential complex, only programme the monitors from their inner door panels, as
indicated in the instruction manualssupplied.
If it is an inner door panel in a residential complex or a door panel for a single building, programme the monitors as shown
below.
Switch off the monitor to be programmed.
Once the telephone is off, press the door release push button.
With the door release push button pressed, switch on the monitor.
To show that the system is ready for programming, the door panel will reproduce a sound
and the picture will appears on the monitor. At this moment, the door release push button
can be released. Lift the handset to establish audio communication with the door panel.
Enter the code of the monitor to be programmed and then press the bell button.
At this moment the door panel will reproduce a sound and the monitor led will
blink.
To programme the monitor as the , switch it off and on again.Master
To programme it as a , press the door release button.Slave
To programme it as a , press the buttonSlave with intercom
.
Each apartment must only have one master unit; if there are parallel units, whether monitors or telephones, they must be
configured as slaves.
Make a call to check that the monitor has been successfully programmed. Programme the other
telephones in the same way.
After programming, exit by pressing .
M S SI
01
01
150
To enter configuration mode, press the key button
three times and then enter the secret
administrator pin (factory code 2718) as
described on p. 129.
CONFIGURATION
2 7 1 8
****
AUDIO AND VIDEO DOOR ENTRY SYSTEM - CODED PANEL WITH DISPLAY
To Next Page
Loading...
