SYSTEM CONFIG
ACCESS CONTROL
RESIDENT LIST
To access the access control menu, follow the steps described on p. 129
and press when the ACCESS CONTROL message lights up.
PROGRAMMING THE DOOR PANEL
Access control menu
R1 OUTPUT TIME
R2 OUTPUT MODE
R2 OUTPUT TIME
R1 OUTPUT MODE
R2 OUTPUT MODE
R2 OUTPUT TIME
R1 OUTPUT MODE
R1 OUTPUT TIME
R2 OUTPUT MODE
R2 OUTPUT TIME
R1 OUTPUT MODE
R1 OUTPUT TIME
R2 OUTPUT MODE
R2 OUTPUT TIME
R1 OUTPUT MODE
R1 OUTPUT TIME
Determines whether the behaviour of relay 1 (located on the N3301/AL
module) will be IMPULSE or STABLE.
To change, press
.
Determines the time in seconds that relay 1 (located on the N3301/AL
module) will be active if it is configured as IMPULSE. Between 01 and
99 seconds can be selected.
To change the time, press and the message ENTER VALUE will
appear; enter the time to be assigned to relay 1 and confirm by
pressing
.
Press the button to restore the previous value.
ENTER VALUE
:03
1 0
R2 OUTPUT MODE
R2 OUTPUT TIME
R1 OUTPUT MODE
R1 OUTPUT TIME
R2 OUTPUT MODE
R2 OUTPUT TIME
R1 OUTPUT MODE
10s
Determines whether the behaviour of relay 2 (located on the N3301/AL
module) will be IMPULSE or STABLE.
To change, press
.
Determines the time in seconds that relay 2 (located on the N3301/AL
module) will be active if it is configured as IMPULSE. Between 01 and
99 seconds can be selected.
To change the time, press and the message ENTER VALUE will
appear; enter the time to be assigned to relay 2 and confirm by
pressing
.
Press the button to restore the previous value.
ENTER VALUE
:03
1 0
R2 OUTPUT MODE
R2 OUTPUT TIME
R1 OUTPUT MODE
R1 OUTPUT TIME
R2 OUTPUT MODE
10s
R1 OUTPUT MODE
R1 OUTPUT TIME
136
AUDIO AND VIDEO DOOR ENTRY SYSTEM - CODED PANEL WITH DISPLAY
Continued overleaf
To Next Page
Loading...
