Goodwe GW10K-ES-C10 - Creating Power Plants

112
Number
Name/Icon
Description
1
Network Name
Applicable to WLAN. Please select the corresponding
network based on your actual situation and communicate
the device with the router or switch.
2
Password
Applicable to WLAN. Enter the password for the network you
actually selected.
3
DHCP
 When the router is using the dynamic IP mode, turn on
the DHCP function.
 When using the router in static IP mode or using a switch,
turn off the DHCP function.
4
IP address
 When DHCP is enabled, there is no need to configure this
parameter.
 When DHCP is turned off, please configure this parameter
according to the information of the router or switch.
5
Subnet mask
6
Gateway address
7
DNS Server
8.4 Creating Power Plants
NOTICE
Login to the SEMS Portal app using the account and password before creating
power plants. If you have any questions, refer to the Plant Monitoring section.
Step 1: Enter the interface for creating a power plant.
Step 2: Carefully read the prompts on the interface and fill in the power plant information
based on actual conditions. (* refers to the mandatory items)
Step 3: Add devices according to the interface prompts to complete the creation of the
power plant.