Goodwe GW10K-ES-C10 - Connecting the PE Cable

63
communication
cable
 Conductor cross-sectional area:
0.2mm²- 0.4mm²
customers.
9
Communication
cable for parallel
connected inverters
CAT 5E and above standard shielded
network cable and RJ45 shielded
connector
Prepared by
customers.
10
Remote shutdown
and NS Protection
communication line
 Copper core twisted pair cable
 Conductor cross-sectional area:
0.2mm²-0.4mm²
Prepared by
customers.
6.4 Connecting the PE cable
WARNING
 The PE cable connected to the enclosure of the inverter cannot replace the PE cable
connected to the AC output port. Make sure that both of the two PE cables are securely
connected.
 Make sure that all the grounding points on the enclosures are equipotentially connected
when there are multiple inverters.
 To improve the corrosion resistance of the terminal, you are recommended to apply silica gel
or paint on the ground terminal after installing the PE cable.
 Connect the PE cable first before installing the equipment. Disconnect the PE cable before
dismantling the equipment.
Inverter
Battery