Install a breaker at the voltage input side of the equipment to prevent personal injury or
equipment damage caused by energized electrical work.
All operations such as transportation, storage, installation, use and maintenance shall
comply with applicable laws, regulations, standards and specifications.
Perform electrical connections in compliance with local laws, regulations, standards and
specifications. Including operations, cables, and component specifications.
Connect cables using the connectors included in the package. The manufacturer shall
not be liable for equipment damage if other connectors are used.
Ensure all cables are connected tightly, securely, and correctly. Inappropriate wiring may
cause poor contacts and damage the equipment.
The PE cables must be connected and secured properly.
To protect the equipment and components from damage during transportation, ensure
that the transportation personnel are professionally trained. All operations during the
transportation have to be recorded. The equipment shall be kept in balance, thus
avoiding falling down.
The equipment is heavy. Please equip the corresponding personnel according to its
weight, so that the equipment does not exceed the weight range of the human body
can carry, and cause personnel injury.
Keep the equipment stable to avoid dumping, which can result in equipment damage
and personal injuries.
Do not apply mechanical load to terminals, otherwise the terminals may be damaged.
If the cable bears too much tension, the connection may be poor. Reserve a certain
length of the cable before connecting it to corresponding ports.
Tie the cables of the same type together, and place cables of different types at least
30mm apart. Do not place the cables entangled or crossed.
Place the cables at least 30mm away from the heating components or heat sources,
To Next Page
Loading...