Step 2: Enable or disable the power limit function based on actual needs.
Step 3: Enter the parameters and tap √. The parameters are set successfully.
Enable Power Limit when power limiting is required
by local grid standards and requirements.
Set the value based on the actual maximum power
feed into the utility grid.
Set the ratio of the primary current to the
secondary current of the external CT.
Method II: Setting via LCD
Step 1: Click on the screen or select the settings icon >System Setup>Quick
Setting>Power Limit through the button to enter the settings page.
Step 2: Set up the function according to actual needs.
Enable Power Limit when power limiting is required
by local grid standards and requirements.
Set the value based on the actual maximum power
feed into the utility grid.
Set the ratio of the primary current to the
To Next Page
Loading...
