Select the corresponding safety code based on the country or region
where the equipment is located.
Select the actual mode for connecting the battery to the inverter. If
there is no battery connected in the system, it is unnecessary to
configure the battery model and working mode, and the equipment
will operate in the self-use mode by default.
Select the actual battery model.
Battery Type only supports: AGM/GEL/Wet Battery (Flooded).
Set the working mode of the device during operation. Supports: self-
use mode and back-up mode.
When the self-use mode is selected, the interface will be displayed as follows. You need to enter
the advanced mode to choose the specific working mode and set the corresponding parameter
values.
To Next Page
Loading...
