Goodwe GW10K-ES-C10 - Page 132

132
Number
Parameter
Description
1
Shadow Scan
Enable Shadow Scan when the PV panels are
severely shadowed to optimize the power
generation efficiency.
9.4.1.2 SPD
This function supports settings through the SolarGo APP only.
Number
Parameter
Description
1
SPD
After enabling SPD, when the SPD module is
abnormal, there will be SPD module abnormal
alarm prompt.
9.4.1.3 Backup Function
This function supports settings through the SolarGo APP only.
After enabling Backup, the battery will power the load connected to the backup port of the
inverter to ensure Uninterrupted Power Supply when the power grid fails.
Number
Parameter
Description
1
UPS Mode - Full Wave
Detection
Check whether the utility grid voltage is too high
or too low.
2
UPS Mode - Half Wave
Detection
Check whether the utility grid voltage is too low.
3
EPS Mode - Supports
LVRT
Stop detecting utility grid voltage.
4
Clear Overload History
Once the power of loads connected to the
inverter BACK-UP ports exceeds the rated load