Goodwe GW10K-ES-C10 - Page 171

171
reconnect to the wireless signal of the smart
dongle again.
3. Ensure successful pairing of Bluetooth.
3
The Ezlink indicator
flashes twice.
1. Make sure that the router is powered on.
2. When communicating via LAN, make sure that
both LAN cable connection and LAN
configuration are proper. Enable or disable DHCP
based on actual needs.
3. When communicating via WiFi, make sure that the
wireless network connection is OK and the
wireless signal strength meets the requirements.
Enable or disable DHCP based on actual needs.
4
The Ezlink indicator
flashes four times.
1. Make sure that the smart dongle is connected to
the router via WiFi or LAN properly, and the router
can access the Internet.
2. If the problem persists, contact the after sales
service.
5
The Ezlink indicator is
off.
Make sure that the inverter is powered on. If the
problem persists, contact the after sales service.
6
The Ezlink indicator is
off.
Make sure that the inverter is powered on.
7
Cannot find router
SSID
1. Put the router nearer to the Smart Dongle. Or add
a WiFi relay device to enhance the WiFi signal.
2. Reduce the number of devices connected to
router.
8
After completing all
configurations, the
Smart Dongle fails
connecting to the
router.
1. Restart the inverter
2. Check if the SSID, encryption method and
password on WiFi configuration page are the
same with that of Router.
3. Restart the router.
4. Put the router nearer to the Smart Dongle. Or add
a WiFi relay device to enhance the WiFi signal.
9
After completing all
Restart the router and the inverter.