Goodwe GW10K-ES-C10 - Page 187

187
10
Voltage Difference
Exception
Leave the battery alone for 12h after
restarting. If the problem persists,
please contact the after-sales service
center.
11
Inconsistency of
battery cells
Contact the after-sales service.
12
Wire harness
exception
Restart the battery. If the problem
persists, please contact the after-sales
service.
13
MOS Open-Circuit
Fault
Restart the battery. If the problem
persists, please contact the after-sales
service.
14
MOS Open-Circuit
Fault
Restart the battery. If the problem
persists, please contact the after-sales
service.
15
Cluster Fault
Please check if the battery model
matches. If not, please contact the
after-sales service center.
16
Interlock failure
Check whether the termination resistor
is installed properly and restart the
battery. Contact the after-sale service if
the problem persists.
17
BMU communication
fault
Restart the battery. If the problem
persists, please contact the after-sales
service.
18
MCU Communication
Fault
Restart the battery. If the problem
persists, please contact the after-sales
service.
19
Open contact sticking
fault
Contact the after-sales service.
20
Pre-charge Failure
Restart the battery. If the problem
persists, please contact the after-sales
service.
21
MOS over-
Power off and wait for 2 hours. If the