Connecting DP752
To setup the DP752 Cordless VoIP Base Station, please follow the steps below:
Figure 4: DP752 Back View
You have two options for power and network connection of the base station: AC power or Power over
Ethernet (PoE).
Note: For better signal range, we recommend installing DP752 with LED side facing toward the usage area.
Ceiling mount is recommended for better coverage.
Connecting via AC power
1. Connect the micro-USB connector into the related port on the base station and connect the other
end of the power adapter into an electrical power outlet.
2. Connect the supplied Ethernet cable between the Internet port on the base station and the Internet
port in your network or the switch/hub device port.
Connecting via PoE
To connect the base station using PoE, you need to connect the Ethernet cable provided (or 3rd party
network cable) between the Network Socket on the base station to Ethernet port of your PoE switch/hub.
Setting up DP730/DP722 Handsets
Please follow below steps to insert batteries into the Handsets:
• Open the battery compartment cover.
• For DP730: Inset Li-ion battery with the electrodes in the bottom left corner.
• For DP722: Insert AAA batteries with correct polarity (+ / -).
• Close the battery compartment cover.
Note: Please charge the batteries fully before using the Handsets for the first time
To Next Page
Loading...
Need help?
General
