DP752 ASSOCIATION WITH DP760 DECT REPEATER
Important Notes:
- DP760 can relay up to 2 concurrent calls.
- After pressing Page/Reset button for more than 2 seconds on the DP760, it will enter AUTO region
mode, in this mode, the three LEDs of right side keep quick blinking, then the DP760 will search
the base signal in the current environment to auto associate with it and then auto switch to the
same region (EU, US or BR) of the base station.
- If you have a DP760 that has FW before 1.0.3.34, you will need upgrade it to 1.0.3.34 first, then do
a factory reset. After that, the unit will support Auto-Region feature and it will enter Auto Region
mode.
Enabling Repeater Mode on DP752
Before associating the DP760 DECT Repeater to your DP752 Base Station, you should firstly enable the
repeater mode on your base station. Please refer following steps to enable the repeater mode on the DP752
base station:
1. Access the Web GUI of your DP752 using the admin’s username and password.
2. Navigate to DECT → General Settings and set Enable Repeater Mode to Yes.
Figure 40: Enable Repeater Mode
3. Press Save and Apply, then Reboot the base to apply the new settings.
To Next Page
Loading...
Need help?
General
