GRAPHTEC CE5000-120AP - Page 21

1-10
Introduction
(7) Tighten all the hexagonal bolts that were temporarily fastened in step 1.
(8) Pull out the sheet support pipes, and attach the sheet to them. Pass the sheet over the center
bar, and fasten the ends to the support pipes using the press-studs.
Sheet
Pass over the center bar
Sheet support pipe
Press-stud
Side view
Sheet
center bar
(9) Attach the stoppers (L/R) to the stock shaft and then attach the shaft to the top of the stand.
Stock shaft
Stopper
Collar