Function Settings and Operations
4-13
4.10 Specifying the INITIAL FEED Length
This function lets you select whether or not to perform an initial feed operation when the cutting plotter is
turned on, when the media set lever is raised and a medium reloaded, or when a new medium is loaded.
During an INITIAL FEED operation, the medium is automatically advanced while the grit rollers make marks
on the medium to prevent it from slipping. The distance the medium is fed is the distance specified in Section
4.30 "Setting the Page Length.
(1) Press the (PAUSE) key to switch to PAUSE mode.
(2) Press the (NEXT) or (PREV.) key until the following menu is displayed.
INITIAL FEED
(3) Press the (ENTER) key to display the INITIAL FEED setting.
INITIAL FEED OFF
(4) Press the or key to select "OFF" or "ON", and then press the
(ENTER) key. To cancel the selection, press the (NEXT) or (PREV.) key.
CHECKPOINT
If the (NEXT) or (PREV.) key is pressed during a feed operation, the feed
operation will be terminated immediately and the medium returned to its original position.
CAUTION
When the initial feed operation has been specified and the power is turned on; the media
set lever raised and a medium loaded; or a new medium loaded; the feed operation will
start immediately. Make sure that there are no obstacles in front of or behind the cutting
plotter.
BLADE WARE SETUP
CUT LINE PAT.
TANGENTIAL
INIT. B
PEN UP SPEED
AUTO PRE FEED
ADVANCED FUNC.
SETUP MENU
TEST
FEED&CUT
CLEAR BUFFER
PEN UP/DOWN
INITIAL FEED
To Next Page
Loading...
