Function Settings and Operations
4-31
4.27 User-specified Settings
This function loads the user-specified (CAD) settings. The COMMAND, ORIGIN POINT or STEP SIZE, RS-
232C TRANSMISSION CONDITIONS, SEPARATOR, TIMEOUT and PAGE LENGTH settings are set here.
(1) Press the (PAUSE) key to switch to PAUSE mode.
(2) Press the (NEXT) or (PREV.) key until the following menu is displayed.
SETUP MENU
(3) Press the (ENTER) key, and then press the (NEXT) or (PREV.) key
until the following menu is displayed.
SELECT USER
(4) Press the (ENTER) key to display the USER SETTINGS setting.
SELECT USER 1
Press the or key to specify a setting from "1" through "8", and then press
the (ENTER) key. To cancel the selection, press the (NEXT) or
(PREV.) key.
(5) Press the (PAUSE) key to cancel PAUSE mode.
Table of user-specified settings
The cutter pen condition settings shown in the following table are the settings that
have been specified for USER 6.
Settings other than those shown in the table are the default settings.
BLADE WARE SETUP
CUT LINE PAT.
TANGENTIAL
INIT. B
PEN UP SPEED
INITIAL FEED
TEST
FEED&CUT
PEN UP/DOWN
CLEAR BUFFER
AUTO PRE FEED
ADVANCED FUNC.
SETUP MENU
USER No. 12345678
COMMAND HP-GL HP-GL GP-GL HP-GL HP-GL HP-GL HP-GL HP-GL
STEP SIZE 0.025 0.025 0.025 0.025 0.025 0.025 0.025 0.025
ORIGIN POINT
L.L. Center L.L. L.L. L.L. Center Center Center
SEPARATOR PG NR JO SP PG SP None None
TIMEOUT 0 0 120 120 1 10 0 0
PAGE LENGTH (mm)
1500 3000 1500 5000 3000 5000 5000 5000
TRANSMISSION
9600, 9600, 9600, 9600, 9600, 19200, 9600, 9600,
CONDITIONS
N81X N81X N81X N81X N81X N81X N81X N81X
STEP PASS –––––0––
PEN UP SPEED
–––––
60 (cm/sec)
––
F
_
CUTON –––––ON––
CUT LINE PAT. –––––OFF––
SPACE REAR –––––12 mm––
– : The currently selected value is used.
Condition SPEED QUALITY FORCE Pen type OFFSET
No. (Acceleration) (Pen force) (Cutter blade) (Cutter offset)
160 1 17 Pen 0
230 1 14 09U 0
330 1 14 09U 0
430 1 14 09U 0
530 1 14 09U 0
630 1 14 09U 0
730 1 14 09U 0
860 1 14 09U 0
To Next Page
Loading...
