Function Settings and Operations
4-27
4.23 Setting the F_CUT Function
When the COMMAND setting is GP-GL, the F_CUT function is used to enable or disable cross-cutting. When
the F_CUT function is enabled, cross-cutting of the medium will be performed even if the cutting plotter is
sent a feed command instructing it not to cut the medium.
(1) Press the (PAUSE) key to switch to PAUSE mode.
(2) Press the (NEXT) or (PREV.) key until the following menu is displayed.
ADVANCED FUNC.
(3) Press the (ENTER) key, and then press the (NEXT) or (PREV.) key
until the following menu is displayed.
F_CUT
(4) Press the (ENTER) key to display the F_CUT setting.
F_CUT ON
Press the or key to specify "ON" or "OFF", and then press the
(ENTER) key. To cancel the selection, press the (NEXT) or (PREV.) key.
(5) Press the (PAUSE) key to cancel PAUSE mode.
CHECKPOINT
The setting is retained in the internal memory even when the power is turned off.
BLADE WARE SETUP
CUT LINE PAT.
TANGENTIAL
INIT. B
PEN UP SPEED
INITIAL FEED
AUTO PRE FEED
SETUP MENU
TEST
FEED&CUT
PEN UP/DOWN
ADVANCED FUNC.
CLEAR BUFFER
To Next Page
Loading...
