Function Settings and Operations
4-21
4.17 Sorting Settings
This function sorts the cutting/plotting data stored in the memory so that cutting is performed last when both
cutting and plotting operations are performed. This is useful for data requiring a large number of movements
on the drawing with the pen raised. If the data received has been sorted using the application software,
sorting the data using the cutting plotter may require additional time. Turning this function off may speed up
the process.
(1) Press the (PAUSE) key to switch to PAUSE mode.
(2) Press the (NEXT) or (PREV.) key until the following menu is displayed.
ADVANCED FUNC.
(3) Press the (ENTER) key, and then press the (NEXT) or (PREV.) key
until the following menu is displayed.
SORT
(4) Press the (ENTER) key to display the sorting setting menu.
SORT OFF
Press or key to select "ON" or "OFF", and then press the (ENTER)
key to confirm. To cancel the selection, press the (NEXT) or (PREV.) key.
(5) Press the (PAUSE) key to cancel PAUSE mode.
CHECKPOINT
• This setting is retained in the memory even when the power is turned off.
• If data for which the cutting/plotting sequence has been set using the application
software is received, the cutting/plotting sequence may be changed if this function is set
to "ON." The function should be set to "OFF" in this case.
BLADE WARE SETUP
CUT LINE PAT.
TANGENTIAL
INIT. B
PEN UP SPEED
INITIAL FEED
AUTO PRE FEED
SETUP MENU
TEST
FEED&CUT
PEN UP/DOWN
ADVANCED FUNC.
CLEAR BUFFER
To Next Page
Loading...
