4-28
Function Settings and Operations
4.24 Setting the LENGTH UNIT
This function specifies the units for coordinates displayed in millimeters or inches.
(1) Press the (PAUSE) key to switch to PAUSE mode.
(2) Press the (NEXT) or (PREV.) key until the following menu is displayed.
ADVANCED FUNC.
(3) Press the (ENTER) key, and then press the (NEXT) or (PREV.) key
until the following menu is displayed.
LENGTH UNIT
(4) Press the (ENTER) key to display the length-unit menu.
LENGTH UNIT mm
Press the or key to select "mm" or "inch," and then press the
(ENTER) key to confirm. To cancel the selection, press the (NEXT) or
(PREV.) key.
(5) Press the (PAUSE) key to cancel PAUSE mode.
CHECKPOINT
The setting is retained in the internal memory even when the power is turned off.
BLADE WARE SETUP
CUT LINE PAT.
TANGENTIAL
INIT. B
PEN UP SPEED
INITIAL FEED
AUTO PRE FEED
SETUP MENU
TEST
FEED&CUT
PEN UP/DOWN
ADVANCED FUNC.
CLEAR BUFFER
To Next Page
Loading...
