5-4
Setting and Using the Special Functions
5.2 Setting Special Functions A
(1) Turn on the cutting plotter while holding down the key. The menus for setting the special
functions are displayed.
“:”, “:” ENABLED
“W” PEN UP
PRIORITY COMD
UP MODE DISABLED
MEDIA ENABLED
HOME ENABLED
B.W.S. DISABLED
CROSSCUT FORCE20
PAUSE KEY MENU
MODEL 7586
PRIORITY COMD
UP MODE DISABLED
MEDIA ENABLED
HOME ENABLED
CIRCLE DEFAULT
B.W.S. DISABLED
CROSSCUT FORCE20
PAUSE KEY MENU
In GP-GL command mode In HP-GL command mode
(2) Scroll up or down to select the required menu using the (NEXT) or (PREV.) key.
(3) Select the setting details using the or key, and press the (ENTER) key to register
the setting. To cancel the selection, press the (NEXT) or (PREV.) key. The next menu
is displayed.
(4) Once all the settings have been made, turn off the cutting plotter.
To Next Page
Loading...
