Basic Settings and Operations
3-5
Setting QUALITY
Sets the acceleration used in cutting.
(1) Press the (COND.) key in READY mode to display the cutter-pen conditions.
(2) Select the setting area (condition number) to be set, and then use the or key to move
the s symbol to the position shown below.
2 09U +1 23 30 2
(3) Press the or key to select the value to be changed in the range specified below
"1", "2"
Press the (ENTER) key to confirm the selection. If other conditions are to be set, press the
or key to move the s symbol to the parameter to be set.
To Next Page
Loading...
