Function Settings and Operations
4-9
4.6 Selecting the Type of Perforated Line
The CUT LINE PAT. function lets you specify one of seven types of cut lines from 0 to 6. If you select OFF, a
solid line is cut. The default setting is 6. Change this setting if the shapes being cut either separate too easily
or are hard to separate.
Using this function, you can select the cut line pattern ratio (the ratio of cut segments to uncut segments in
each line) by specifying the LINE TYPE NO. The smaller the value, the shorter the uncut segments and the
easier it is for cut shapes to be separated. When the specified LINE TYPE NO. properly suits the medium you
are using, cut shapes can be easily separated after cutting but will not come loose during cutting.
(1) Press the (PAUSE) key to switch to PAUSE mode.
(2) Press the (NEXT) or (PREV.) key until the following menu is displayed.
CUT LINE PAT.
(3) Press the (ENTER) key to display the PERF. LINE TYPE setting.
LINE TYPE NO OFF
(4) Press the or key to select "OFF" or a value within the range "0" to" 6,"
and then press the (ENTER) key. To cancel the selection, press the
(NEXT) or (PREV.) key.
(5) Press the (PAUSE) key to cancel PAUSE mode.
CHECKPOINT
The setting is retained in the internal memory even when the power is turned off.
BLADE WARE SETUP
TANGENTIAL
INIT. B
PEN UP SPEED
INITIAL FEED
AUTO PRE FEED
ADVANCED FUNC.
SETUP MENU
TEST
FEED&CUT
CLEAR BUFFER
PEN UP/DOWN
CUT LINE PAT.
To Next Page
Loading...
