GRAPHTEC CE5000-120AP - 4.1 PAUSE Menu List

4-2
Function Settings and Operations
4.1 PAUSE Menu List
Pressing the (PAUSE) key in READY mode displays the PAUSE menu, enabling the various settings to
be made. Select the required menu by scrolling through the list using the (NEXT) or (PREV.) key.
SELECT USER
COMMAND
RS-232C
PAGE LENGTH
SEPARATOR
TIMEOUT
PAPER READY TIME
PAPER LOAD
CLEAR BUFFER
DISTANCE ADJUST
AXIS ALIGNMENT
PLOT AREA
EXPAND
ROTATE
SORT
SPACE REAR
OFFSET FORCE
INIT. DOWN FORCE
STEP PASS
OFFSET ANGLE
F_CUT
LENGTH UNIT
FEED&CUT
BLADE WARE SETUP
PEN UP/DOWN
CUT LINE PAT.
TANGENTIAL
INIT. B
PEN UP SPEED
INITIAL FEED
AUTO PRE FEED
ADVANCED FUNC.
SETUP MENU
TEST
PEN 1/2 ADJ
COPY
4.2 Clearing the Buffer Memory
4.3 Setting the FEED & CUT function
4.4 Blade Wear Detection (When Blade Wear Setup is On)
4.5 Raising and Lowering the Pen
4.6 Selecting the Type of Perforated Line.
4.7 Setting TANGENTIAL Mode
4.8 Selecting the Blade Tip's Initial Position
4.9 Setting the PEN UP SPEED
4.10 Specifying the INITIAL FEED Length
4.11 Setting AUTO PRE-FEED
4.35 TEST Mode
4.25 Adjusting the Distance Between the Pens
4.26 Cutting/Plotting Using the Buffer Memory (COPY Function)
4.12 Distance Adjustment
4.27 User-specified Settings
4.28 Setting the Format of Data to be Received
4.29 Interface Settings
4.30 Setting the PAGE LENGTH
4.31 Setting the SEPARATOR Function
4.32 Setting the TIMEOUT Function
4.33 Setting the PAPER READY TIME
4.34 Setting the PAPER LOAD Function
4.13 Aligning the Coordinate Axes
4.14 Setting the Cutting/Plotting Area
4.15 Expanding the Cutting/Plotting Area
4.16 Rotating the Coordinate Axes
4.17 Sorting Settings
4.18 Specifying the SPACE REAR Distance
4.19 Setting the OFFSET FORCE (Initial Cutting Force)
4.20 Setting the Initial Down Force
4.21 Setting the STEP PASS
4.22 Setting the OFFSET ANGLE
4.23 Setting the F_CUT Function
4.24 Setting the LENGTH UNIT
(ENTER) key
(ENTER) key