GRAPHTEC CE5000-120AP - 4.2 Clearing the Buffer Memory

Function Settings and Operations
4-3
4.2 Clearing the Buffer Memory
This function deletes the data sent to the cutting plotter. It is used to abort cutting while it is in progress.
(1) Press the (PAUSE) key to switch to PAUSE mode.
(2) Stop the transmission of data from the computer if this is in progress.
(3) Press the (NEXT) or (PREV.) key until the following menu is displayed.
CLEAR BUFFER
(4) Press the (ENTER) key to display the clear-buffer-memory menu.
CLEAR <YES>
(5) Press the or key to select "YES" or "NO," and then press the
(ENTER) key. To cancel the selection, select "NO" and press the (ENTER)
key, or press the (NEXT) or (PREV.) key .
BLADE WARE SETUP
CUT LINE PAT.
TANGENTIAL
INIT. B
PEN UP SPEED
INITIAL FEED
AUTO PRE FEED
ADVANCED FUNC.
SETUP MENU
TEST
FEED&CUT
PEN UP/DOWN
CLEAR BUFFER