Function Settings and Operations
4-11
4.8 Selecting the Blade Tip's Initial Position
Whenever the cutting plotter is turned on or any of its cutting condition settings changed, initial blade control
is performed to position the cutter pen's blade on the medium so that the blade's tip is properly oriented. This
function is called the "Initial Blade Position".
When 2mm is selected, initial blade control is performed at a position 2 mm below the starting position for
cutting.
When OUTSIDE is selected, initial blade control is performed outside of the effective cutting area.
(1) Press the (PAUSE) key to switch to PAUSE mode.
(2) Press the (NEXT) or (PREV.) key until the following menu is displayed.
INIT. B
Press the (ENTER) key to display the INIT. BLADE POS. setting.
INIT. B 2mm
(3) Press the or key to select "2mm" or "OUTSIDE", and then press the
(ENTER) key. To cancel the selection, press the (NEXT) or (PREV.) key.
(4) Press the (PAUSE) key to cancel PAUSE mode.
CHECKPOINT
The setting is retained in the internal memory even when the power is turned off.
BLADE WARE SETUP
CUT LINE PAT.
TANGENTIAL
PEN UP SPEED
INITIAL FEED
AUTO PRE FEED
ADVANCED FUNC.
SETUP MENU
TEST
FEED&CUT
CLEAR BUFFER
PEN UP/DOWN
INIT. B
To Next Page
Loading...
