GRAPHTEC CE5000-120AP - 2.4 If the sensor detects that there is no paper left while roll paper is being cut

2-12
Setting up The Cutter Plotter
2.4 If the sensor detects that there is no paper left while roll paper is being cut
If the media sensor detects that there is no paper left during a roll paper cutting operation, cutting is stopped
automatically. Check the length of paper remaining, and select whether to continue or abort the cutting
operation.
(1) If the media sensor detects that there is no paper left during a roll paper cutting operation,
cutting is stopped automatically and the following message is displayed.
No Media
(2) If the (ENTER) key is pressed, plotting/cutting is continued and subsequent paper end
detection is not performed. Moreover, if the media set lever is lowered and a media feed
operation performed, paper end detection will be performed once again.