2-8
Setting up The Cutter Plotter
(12) Move the stock shaft stopper to the FREE position.
FREE position:
This is the status when the lever has been pushed down and engaged, and the silver-colored
section is hidden. The stock shaft rotates in the FREE status.
LOCKFREE
CAUTION
While cutting or plotting is in
progress, please keep your
hands, hair, etc., away from
the shaft holder and the collar.
Black sticker Silver-colored section
(13) Raising the media set lever displays a menu for selection of the media mode. Select the media
mode.
ROLL1 PRESS ENTR
CHECKPOINT
If the "REALIGN ROLLERS" message is displayed when the medium is detected, either the right-
hand push roller is not positioned over the right-hand wide grit roller or the left-hand or center
push roller is not positioned over a grit roller. Check to confirm that they are positioned correctly.
(14) Pressing the or key displays "ROLL1 PRESS ENTR" and "ROLL2 PRESS ENTR".
Select "ROLL1 PRESS ENTR" or "ROLL2 PRESS ENTR", and then press the (ENTER)
key to confirm.
When "ROLL1 PRESS ENTR" is selected, the leading edge and width of the medium are
detected. Select this mode to begin cutting from the leading edge.
When "ROLL2 PRESS ENTR" is selected, only the medium width is detected. Select this
mode to begin cutting at a point beyond the leading edge.
(15) After "ROLL1 PRESS ENTR" or "ROLL2 PRESS ENTR" has been selected, the following
message is displayed.
UNLOCK MEDIA PRESS ENTER KEY
Displayed alternately
Move the stopper to the FREE position and then press the (ENTER) key.
(16) After the medium size has been detected, the pen carriage returns to the origin point and the
cutting plotter awaits cutting data. If the INTERFACE conditions or COMMAND mode have not
yet been set, they should be set. If they have already been set, adjust the cutter pen. Once the
cutter pen has been adjusted, the cutting plotter is ready to perform cutting, so cutting data can
be sent from the application software on the computer.
Precautions when using roll paper
If there is a problem with the paper feed and the paper is not being fed correctly into the basket,
open the media basket out to its maximum size and lower the speed.
CHECKPOINT
Be sure to remove media on which the cutting or plotting operation has been completed from the media
basket. If media is left in the basket while the next cutting or plotting operation is being performed,
paper shift or other malfunctions may occur.
To Next Page
Loading...
