iv
Safety Precautions
Safety Precautions
CAUTION
Do not use or store the cutting plotter in a location exposed to direct sunlight or the direct draft of an air
conditioner or heater.
• Such locations may impair the performance of the cutting plotter.
Do not use the cutting plotter in an excessively dusty or humid location.
• Such locations may impair the performance of the cutting plotter.
Do not use the cutting plotter in a location subject to excessive mechanical vibration or electrical noise.
• Use in such locations may impair the performance of the cutting plotter.
Do not place any receptacle containing water or other fluid on top of the cutting plotter.
• Fluid falling inside the cutting plotter may cause electric shock or a fire
hazard due to current leakage.
If water or foreign matter enters the cutting plotter, discontinue use. Turn off the power and unplug the
power cord from the electrical socket.
• Use of the cutting plotter in such a condition may result in electric shock or
a fire hazard due to current leakage.
• Contact your sales representative or nearest Graphtec vendor for repairs.
When disconnecting the power cord or interface cable, do not pull on the cord/cable.
• Such action will damage the cord/cable, resulting in a fire hazard or electric
shock.
Prohibited
Unplug the power
cord from the socket
Prohibited
Prohibited
Beware of
electric shock
Avoid fluids
Beware of
electric shock
Prohibited
To Next Page
Loading...
