Gree U-Match 5 Series - Removal of Compressor;Gas Liquid Separator

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
119
Removal of front panel
Note: Before removing the front panel, make sure power is cut off.
Step Picture Work instruction
9. Install the front side plate.
 Fix the clasps on both sides
of the plate and tighten up
the screws.
10. Install the upper cover plate.
 Tighten up the screws
around the upper cover
plate.
Model: GUD100W/NhA-T, GUD125W/NhA-T, GUD140W/NhA-T, GUD100W/NhA-X, GUD125W/NhA-X,
GUD140W/NhA-X
Removal of compressor/gas liquid separator
Note: Before removing the compressor/gas liquid separator, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
1. Remove wires.
 Loosen the securing screws
of the wires with a
screwdriver.
 Remove the wires.
Note: When removing the
wires, mark the wire
terminals corresponding to
their color so as to avoid
misconnection.