GREE         U-Match 5 SERIES UNIT SERVICE MANUAL 
145 
Removal of fan and motor 
Note: Before removing the motor, make sure power is cut off.   
Step  Picture  Work instruction 
7.  Re-install the device in 
a reverse order of the 
removal procedure.   
 
  Re-install the device in a reverse 
order of the removal procedure. 
Then connect power and test it.   
 
Removal of air return filter 
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components. Do not 
place the filter near any heat source.   
Step  Picture  Work instruction 
Remove air return 
filter.   
 
  Press the air return filters on the 
guide way sponge. There are 2 or 
3 air return filters.   
 
Removal of the cover of electric box and the electric box 
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components, especially 
the electric components. Do not hit or beat.   
Step  Picture  Work instruction 
1.  Remove the cover 
of electric box.   
 
  Loosen the screws as shown by 
the circle and the box. Remove 
the box in the direction shown 
by the arrow.   
2.  Remove the 
electric box. 
 
  Loosen the securing screws and 
remove the electric box.