Gree U-Match 5 Series - Removal of Condenser

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
124
Removal of fan and motor
Note: Before removing the fan, make sure power is cut off.
Step Picture Work instruction
5. Install the fan.
 Install the fan in place. Put
on the gasket and use a
wrench to secure the
screw nut.
Note: After installing the
fan, turn the fan by hand to
see if it can run normally. If
not, please check for the
reason.
6. Install the grill.
 After replacing the motor,
use a screwdriver to
tighten up the screw bolt
that secures the motor.
Arrange the wires
according to the wiring
diagram.
Model: GUD100W/NhA-T, GUD125W/NhA-T, GUD140W/NhA-T, GUD100W/NhA-X, GUD125W/NhA-X,
GUD140W/NhA-X
Removal of condenser
Note: Before removing the condenser, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
1. Remove the panels.
 Remove the upper, lower and
front panels.
2. Remove the electric box.
 Loosen the wire clamp at the
bottom of the electric box.
 Unscrew the screws of electric
box.
 The connection wires inside and
outside the electric box should be
removed.