Gree U-Match 5 Series - Removal of Water Tray; Removal of Evaporator

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
146
Removal of water tray
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components.
Step Picture Work instruction
1. Remove the cover plate.
 Loosen the screws of cover
plate and then remove the cover
plate. (As shown in the picture,
the circle indicates 6 screws of
the cover plate.)
2. Remove the water tray.
 Loosen the screws of water trap.
Pull it up and remove it. The
removed water tray is as shown
in the picture.
Removal of evaporator
Note: Make sure power is cut off. Take good care of the copper pipe and aluminum fins. If the removal takes a long time, please put
the copper pipe under pressure.
Step Picture Work instruction
1. Remove the screws on
the side plate of
evaporator.
 Remove the screws of
evaporator and the screws that
connect the upper cover plate
to the left and right side plates.
2. Remove the sealing plate
the connects to the
evaporator valve and the
screws that connect to
the flange.
 Remove the screws of the
sealing plate of valve. Then
remove the sealing plate of
valve. Remove the screws that
connect the evaporator to the
flange.
3. Remove the evaporator.
 Take off the evaporator. The
removed evaporator is as
shown in the picture.