Gree U-Match 5 Series - Page 130

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
127
Removal of electronic expansion valve
Note: Before removing the electronic expansion valve, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
2. Remove the fixed block.
 Remove the fixed block
between the electronic
expansion valve and the pipe.
3. Remove the electronic
expansion valve.
 Take off the coil of electronic
expansion valve.
 Loosen the connection pipe
of electronic expansion valve
by welding. Then remove the
connection pipe.
Note: When welding the pipe,
do not let the flame bunt the
other components.
4. Take out the electronic
expansion valve.
 Take out the electronic
expansion valve.