-8-
Model G0750G (Mfg. Since 11/12)
The information contained herein is deemed accurate as of 5/22/2013 and represents our most recent product specifications.
Due to our ongoing improvement efforts, this information may not accurately describe items previously purchased.
PAGE 2 OF 3Model G0750G
Main Specifications:
Operation Info
Swing Over Bed......................................................................................................................................... 12 in.
Distance Between Centers........................................................................................................................ 36 in.
Swing Over Cross Slide............................................................................................................................... 7 in.
Swing Over Saddle.......................................................................................................................... 11-11/32 in.
Swing Over Gap........................................................................................................................................ 17 in.
Maximum Tool Bit Size............................................................................................................................. 5/8 in.
Compound Travel.................................................................................................................................. 3-1/4 in.
Carriage Travel.................................................................................................................................... 30-1/2 in.
Cross Slide Travel............................................................................................................................... 5-5/16 in.
Headstock Info
Spindle Bore........................................................................................................................................... 1.57 in.
Spindle Taper............................................................................................................................................ MT#5
Number of Spindle Speeds............................................................................................................................... 9
Spindle Speeds......................................................................................................................... 60 – 1500 RPM
Spindle Type................................................................................................................................ D1-5 Camlock
Spindle Bearings................................................................................................ High-Precision Tapered Roller
Spindle Length........................................................................................................................................... 17 in.
Spindle Length with 3-Jaw Chuck....................................................................................................... 21-3/4 in.
Spindle Length with 4-Jaw Chuck....................................................................................................... 21-1/4 in.
Spindle Length with Faceplate............................................................................................................ 18-1/2 in.
Tailstock Info
Tailstock Quill Travel............................................................................................................................. 3-3/4 in.
Tailstock Taper.......................................................................................................................................... MT#3
Tailstock Barrel Diameter..................................................................................................................... 1.575 in.
Threading Info
Number of Longitudinal Feeds....................................................................................................................... 32
Range of Longitudinal Feeds........................................................................................ 0.0020 – 0.0548 in./rev.
Number of Cross Feeds................................................................................................................................. 32
Range of Cross Feeds................................................................................................... 0.0007 – 0.0187 in./rev
Number of Inch Threads................................................................................................................................. 34
Range of Inch Threads...................................................................................................................... 4 – 56 TPI
Number of Metric Threads.............................................................................................................................. 26
Range of Metric Threads............................................................................................................... 0.4 – 7.0 mm
Dimensions
Bed Width............................................................................................................................................. 7.126 in.
Leadscrew Diameter................................................................................................................................. 7/8 in.
Leadscrew TPI........................................................................................................................................... 8 TPI
Leadscrew Length............................................................................................................................... 46-3/4 in.
Steady Rest Capacity................................................................................................................. 3/16 – 1-1/2 in.
Follow Rest Capacity....................................................................................................................... 1/4 – 3/4 in.
Faceplate Size........................................................................................................................................... 10 in.
Feed Rod Diameter.................................................................................................................................. 3/4 in.
Floor to Center Height......................................................................................................................... 46-1/4 in.
Construction
Base..................................................................................................................................................... Cast Iron
Headstock............................................................................................................................................ Cast Iron
Headstock Gears............................................................................................................ Flame-Hardened Steel
Bed........................................................................................ Induction-Hardened, Precision-Ground Cast Iron
Body..................................................................................................................................................... Cast Iron
Stand............................................................................................................................................. Formed Steel
Paint......................................................................................................................................................... Epoxy
To Next Page
Loading...
Need help?
General
