Grizzly G0776 - Machine Data Sheet: Continued Specifications; Headstock, Tailstock, and Dimension Data

Model G0776 (Mfd. Since 7/14)
-9-
The information contained herein is deemed accurate as of 11/16/2017 and represents our most recent product specifications.
Due to our ongoing improvement efforts, this information may not accurately describe items previously purchased.
PAGE 2 OF 3
Model G0776
Headstock Info
Spindle Bore............................................................................................................................. 1.57 in. (40 mm)
Spindle Taper............................................................................................................................................ MT#5
Spindle Threads.......................................................................................................................... M42 X 1.5 mm
Number of Spindle Speeds............................................................................................................................... 8
Spindle Speeds......................................................................................................................... 70 – 2000 RPM
Spindle Type............................................................................................................................................... D1-4
Spindle Bearings......................................................................................................................... Tapered Roller
Spindle Length................................................................................................................................... 16-5/16 in.
Spindle Length with 3-Jaw Chuck..................................................................................................... 21-3/16 in.
Spindle Length with 4-Jaw Chuck....................................................................................................... 20-1/2 in.
Spindle Length with Faceplate............................................................................................................ 17-3/4 in.
Tailstock Info
Tailstock Quill Travel................................................................................................................................... 4 in.
Tailstock Taper.......................................................................................................................................... MT#3
Tailstock Barrel Diameter...................................................................................................................... 1-1/4 in.
Threading Info
Number of Longitudinal Feeds....................................................................................................................... 48
Range of Longitudinal Feeds........................................................................................ 0.0019 – 0.0472 in./rev.
Number of Cross Feeds................................................................................................................................. 36
Range of Cross Feeds.................................................................................................. 0.0014 – 0.0116 in./rev.
Number of Inch Threads................................................................................................................................. 36
Range of Inch Threads...................................................................................................................... 4 – 60 TPI
Number of Metric Threads.............................................................................................................................. 32
Range of Metric Threads.................................................................................................................. 0.4 – 7 mm
Dimensions
Bed Width............................................................................................................................................ 7-1/16 in.
Carriage Leadscrew Diameter.............................................................................................................. 0.866 in.
Leadscrew TPI........................................................................................................................................... 8 TPI
Carriage Leadscrew Length................................................................................................................ 44-1/2 in.
Steady Rest Capacity.................................................................................................................. 0.31 – 2.95 in.
Follow Rest Capacity................................................................................................................... 0.31 – 2.16 in.
Faceplate Size........................................................................................................................................... 10 in.
Feed Rod Diameter.............................................................................................................................. 0.787 in.
Floor to Center Height..................................................................................................................... 45-11/16 in.
Other
Carriage Handwheel Graduations.......................................................................................................... 0.02 in.
Carriage Handwheel Revolution............................................................................................................. 0.66 in.
Cross Slide Handwheel Graduations.................................................................................................... 0.002 in.
Cross Slide Handwheel Revolution.......................................................................................................... 0.2 in.
Compound Handwheel Graduations..................................................................................................... 0.001 in.
Compound Handwheel Revolution........................................................................................................... 0.1 in.
Tailstock Handwheel Graduations........................................................................................................ 0.001 in.
Tailstock Handwheel Revolution............................................................................................................... 0.1 in.
Construction
Base........................................................................................................................................................... Steel
Headstock............................................................................................................................................ Cast Iron
End Gears...................................................................................................................... Flame-Hardened Steel
Bed...................................................................................................................... Induction-Hardened Cast Iron
Body..................................................................................................................................................... Cast Iron
Stand.......................................................................................................................................................... Steel
Paint Type/Finish...................................................................................................................................... Epoxy