Grizzly G0776 - Section 4: Operation - Setting Spindle Speed; Setting Spindle Speed Using Levers

Model G0776 (Mfd. Since 7/14)
-49-
Figure 63. Spindle range and speed levers.
Spindle
Range
Lever
Spindle
Speed
Lever
Setting Spindle Speed
The spindle range lever and spindle speed lever,
shown in Figure 63, are used to select one of the
8 spindle speeds.
To avoid damaging gears, ALWAYS make
sure the spindle is completely stopped
BEFORE moving the spindle speed levers.
The chart below shows the various combinations
of lever positions for achieving a desired speed.
Figure 64. Spindle speed chart and applicable
spindle lever positions.
70115300
755 46020001255
190
Spindle Speed RPM
X
min
Spindle
Range
Lever
Spindle
Speed
Lever
The spindle speed and range levers control the
gear configuration in the headstock to produce
the selected spindle speed.
Configuration Example
Figure 65 shows the levers positioned for a
spindle speed of 460 RPM.
Note: If the spindle speed levers do not easily
adjust into position, rotate the spindle by hand
while you apply pressure to the lever. When the
gears align, the lever will easily move into place.
If you have trouble rotating the spindle by hand,
you can use the spindle key or a chuck key to get
additional leverage—be sure to remove the key
when you are done.
Figure 65. Spindle speed set to 460 RPM.
Spindle
Speed Lever
Spindle Range
Lever
70115300
755 46020001255
190
X
min