Grundfos CME User Manual

English (GB)
27
1)
Only available if an advanced functional module, type FM 300, is fitted.
2)
Only available if Grundfos GO is connected to a multipump system.
Continued from page 26.
"Settings"
CRE, CRIE,
CRNE,
SPKE, MTRE
CME
Multipump
system
Section Page
"Limit 1 exceeded" ●●●
13.16 Limit-exceeded function 44
"Limit 2 exceeded" ●●●
"Alternating operation,
time"
●
2)
13.45 "Multi-pump setup"
(Setup of multi-pump system)
54
"Time for pump
changeover"
●
1) + 2)
"Standstill heating" ●● 13.22 Standstill heating 48
"Motor bearing monitoring" ●● 13.23 Motor bearing monitoring 48
"Service" ●● 13.24 "Service" 49
"Date and time" ●●
1)
13.28 "Date and time" (Set date
and time)
50
"Store settings" ●●
13.34 "Store settings" (Store
actual settings)
51
"Recall settings" ●●
13.35 "Recall settings" (Recall
stored settings)
51
"Undo" ●●●13.35.1 "Undo" 51
"Pump name" ●●●13.36 "Pump name" 51
"Connection code" ●●●13.37 "Connection code" 52
"Unit configuration" ●●
13.29 "Unit configuration"
(Units)
50
"Alarms and warnings"
CRE, CRIE,
CRNE,
SPKE, MTRE
CME
Multipump
system
Section Page
"Alarm log" ●●●13.39 Alarm log 52
"Warning log" ●●●13.40 Warning log 53
"Reset alarm" button ●●●
"Assist"
CRE, CRIE,
CRNE,
SPKE, MTRE
CME
Multipump
system
Section Page
"Assisted pump setup" ●● 13.42 Assisted pump setup 53
"Assisted fault advice" ●●●13.47 Assisted fault advice 57
"Multi-pump setup" ●●●
13.45 "Multi-pump setup"
(Setup of multi-pump system)
54

Grundfos CME Specifications

General

Liquid temperature range	0 °C to +60 °C
Maximum operating pressure	10 bar
Series	CME
Frequency	50/60 Hz
Max Pressure	10 bar
Pump Type	Centrifugal
Material	Stainless steel
Applications	pressure boosting, irrigation
Pumped liquid	Clean water
Approvals	CE
Max Liquid Temperature	60°C
Power Supply	1-phase or 3-phase