English (GB)
49
13.24 "Service"
"Time to next service" (Motor bearing service)
This display shows when to replace the motor
bearings. The controller monitors the operating
pattern of the motor and calculates the period
between bearing replacements.
Displayable values:
• "in 2 years"
• "in 1 year"
• "in 6 months"
• "in 3 months"
• "in 1 month"
• "in 1 week"
•"Now"
"Bearing replacements"
Indicates the number of bearing replacements that
have been done during the lifetime of the motor.
"Bearings replaced" (Motor bearing
maintenance)
When the bearing monitoring function is active, the
controller gives a warning when the motor bearings
are due to be replaced.
When you have replaced the motor bearings, press
[Bearings replaced].
13.25 "Number" (Pump number)
You can allocate a unique number to the pump. This
makes it possible to distinguish between pumps in
connection with GENIbus communication.
Factory setting
See section 24. Factory settings.
13.26 "Radio communication"
(Enable/disable radio comm.)
You can set the radio communication to either
enabled or disabled. You can use this function in
areas where radio communication is not allowed.
Factory setting
See section 24. Factory settings.
13.27 Language
This menu is only available in the advanced control
panel.
In this menu, you select the desired language. A
number of languages is available.
Factory setting
See section 24. Factory settings.
Pump variant
"Number"
(Pump number)
CME ●
CRE, CRIE, CRNE,
SPKE, MTRE
●
Pump variant
"Radio communication"
(Enable/disable radio
comm.)
CME ●
CRE, CRIE, CRNE,
SPKE, MTRE
●
IR communication remains active.
Pump variant Language
CME ●
CRE, CRIE, CRNE,
SPKE, MTRE
●
To Next Page
Loading...
Need help?
General
