Grundig RCD 2000 - Volume and Tone Control; Selecting Loudspeaker Room

24
VOLUME AND TONE
_____________________________________________
Settings for one pair of loudspeakers
The volume, bass, treble and balance levels can be set separately for each pair
of loudspeakers.
The first pair of loudspeakers (Room 1) should be in the same room as the HiFi.
Selecting a pair of loudspeakers
1 Press the »SOUND« button on the remote control.
2 From the »SOUND« menu, select the »SELECT ROOM« item by pressing
»A« or »S« and then »OK« to confirm.
– The »SELECT ROOM« menu appears.
Note:
If you are only using one pair of loudspeakers you cannot make a selection
in this menu.
3 From the »SELECT ROOM« menu, select the loudspeakers in the required
room by pressing »–« or »+« and then »OK« to confirm.
– The »SOUND« menu reappears in the display, with the number of the
room in which the loudspeakers are located in the top right corner.
Note:
All the following volume and tone settings are applied to the loudspeakers in
the selected room.
SOUND
SELECT ROOM
TONE CONTROL
SOUND MODE
BACK ļĻ
SELECT ROOM
ROOM 1
BACK ê +