SPECIAL SETTINGS
____________________________________________________________________
ENGLISH
49
Switching the loudspeakers in Room 1 to Cable
mode
This option is available in case you do not want to use radio signals for the
loudspeakers in Room 1, but rather to connect them to the HiFi using LF cables.
Note:
Before you implement this setting the loudspeakers must first be connected to
the HiFi using cinch cables and installed (see Page 16).
1 Switch on the HiFi and all the loudspeakers.
2 Press the »CONTROL« button on the remote control.
3 From the »CONTROL« menu, select the »AUDIO CHANNEL« item by
pressing »A« or »S« and then »OK« to confirm.
– Display: »ROOM 1: RF«.
4 Select »LINK« to switch the loudspeakers to Cable mode.
– The display changes to »ROOM 1: LINE«.
Note:
If you change the loudspeakers back to wireless operation, repeat the
setting. The display changes back to »
ROOM 1: RF«
AUDIO CHANNEL
CHANNEL: 3
ROOM 1: RF
BACK LINK +
-
AUDIO CHANNEL
CHANNEL: 3
ROOM 1: LINE
BACK LINK +
-
To Next Page
Loading...
Need help?
General
