48
SPECIAL SETTINGS
____________________________________________________________________
Changing the communication channel of the HiFi
and the loudspeakers
If interference occurs during sound transmission, which can happen if another
device is using the same frequency, you can change the communication
channel.
Seven channels are available. When you first set up the system Channel 1 is
selected by default.
1 Switch on the HiFi system, the remote control and the loudspeakers in
Room
1 only.
2 Press the »CONTROL« button on the remote control.
3 From the »CONTROL« menu, select the »AUDIO CHANNEL« item by
pressing »A« or »S« and then »OK« to confirm.
– The selected channel appears in the remote control display.
4 Select the new channel (from 2 to 7) by pressing »– « or »+«.
Switching the HiFi system to Vertical mode
1 Switch off the HiFi by pressing the »OI« button.
2 Press »VOLUME +« on the HiFi and keep it pressed while you switch the
HiFi on again with the »OI« button.
– The HiFi display reads: »HORIZONTAL«.
3 Press »VOLUME +« on the HiFi to switch the system to Vertical operating
mode.
– The HiFi display reads: »VERTICAL«.
4 Confirm the setting by pressing »
4
« on the HiFi.
5 Open the CD compartment by pressing »OPEN/CLOSE« an on the HiFi
system.
6 Switch off the HiFi by pressing the »OI« button.
7 Turn the HiFi system around by 180° (see the illustrations).
8 Hang the HiFi system on the wall (see Page 13).
AUDIO CHANNEL
CHANNEL: 3
ROOM 1: RF
BACK LINK
-
+
M
U
T
E
ľ
ĵ
ĵ
ĵ
ĵ
O
P
E
N
/
C
L
O
S
E
S
O
U
N
D
M
O
D
E
S
O
U
R
C
E
ǵ
ǵ
O
N
/
O
F
F
Ǽ
180°
ON/OFF
Ǽ
MUTE
ľ
ĵĵ
ĵĵ
OPEN/CLOSE
SOUND MODE
SOURCE
ǵ
To Next Page
Loading...
Need help?
General
