GW Instek GDS-1104B - Go_Nogo Commands; Gonogo:clear; Gonogo:execute

GDS-1000B Programming Manual
148
Go_NoGo Commands
The GoNoGo APP must first be launched (or use the command,
“:GONogo:SCRipt”) before any of the Go_NoGo or Template
commands can be used.
:GONogo:CLEar ......................................................... 148
:GONogo:EXECute .................................................... 148
:GONogo:FUNCtion .................................................. 149
:GONogo:NGCount .................................................. 149
:GONogo:NGDefine .................................................. 149
:GONogo:SOURce .................................................... 150
:GONogo:VIOLation ................................................. 150
:GONogo:SCRipt ....................................................... 150
:TEMPlate:MODe ...................................................... 151
:TEMPlate:MAXimum ................................................ 151
:TEMPlate:MINimum ................................................ 151
:TEMPlate:POSition:MAXimum ................................ 152
:TEMPlate:POSition:MINimum ................................ 152
:TEMPlate:SAVe:MAXimum ...................................... 152
:TEMPlate:SAVe:MINimum ...................................... 153
:TEMPlate:TOLerance ................................................ 153
:TEMPlate:SAVe:AUTo............................................... 153
:GONogo:CLEar
Description
Clears the Go/NoGo counter.
Syntax
:GONogo:CLEar
:GONogo:EXECute
Description
Enables or disables the Go/NoGo function or
queries its state.
Syntax
:GONogo:EXECute {OFF|ON|?}
Set
Set
Query