GW Instek GDS-1104B - Data Logging Commands; Datalog:state

GDS-1000B Programming Manual
154
Data Logging Commands
The data logging commands are only applicable after the optional
Data Log app has been installed.
:DATALOG:STATE ..................................................... 154
:DATALOG:SOURce .................................................. 155
:DATALOG:SAVe ....................................................... 155
:DATALOG:INTerval .................................................. 156
:DATALOG:DURation ................................................ 157
:DATALOG:STATE
Description
Sets or queries the state of the data logging app.
Note
This command is only applicable when the
Datalog app is installed. See the Datalog user
manual for details.
Syntax
:DATALOG:STATE {OFF|ON|?}
Related
commands
:DATALOG:SOURce
:DATALOG:SAVe
:DATALOG:INTerval
:DATALOG:DURation
Parameter/
Return parameter
OFF
Turns the data logging off.
ON
Turns the data logging on.
Example
:DATALOG:STATE ON
Turns the data logging app on.
Set
Query