To Next Page

To Previous Page

REMOTE CONTROL

141

Command

:SOURce[1|2]:VOLTage?

Function

Queries the output voltage setting.

Example

:SOURce2:VOLTage?

Queries the output voltage setting on CH2.

Command

VSET<X>?

Function

Returns the output voltage setting.

Description

X ：1= CH1, 2= CH2

Example

VSET1?

Returns the CH1 output voltage setting.

Command

:SOURce[1|2]:RESistor < NRf >

Function

Set the resistor value.

Description

NRF

1-1000

Example

:SOURce2:RESistor 1000

Set the resistor value as 1000Ω for CH2.

Command

:SOURce[1|2]:RESistor?

Function

Queries the setting resistor value.

Example

:SOURce2:RESistor?

Queries the setting resistor value and returns the

readback value for CH2.

Command

:SOURce:CURRent:ALL?

Function

Queries the setting current value in all channnels.

Table of Contents3
Safety Instructions7
Safety Symbols7
Safety Guidelines8
Power Cord for the United Kingdom11
Overview13
Introduction13
Key Features16
Front Panel18
Rear Panel24
Constant Voltage/Constant Current Crossover Characteristics26
Getting Started27
Start up28
Load Connection29
Select Front/Rear Panel Output31
Turning the Output On/Off32
Basic Operation33
Display Change34
Source Function37
Independent Output Mode43
Tracking Series and Tracking Parallel Modes45
Load Function50
Sequence Function54
Set Sequence Output54
Set Group Parameter57
Construct Templet58
Menu Tree61
Save and Recall63
Delay Function66
Set Delay Output66
Set Group Parameter69
Menu Tree72
Save and Recall74
Monitor Function77
Set Monitor77
Recorder Function81
Set Recorder81
External I/O Control85
Key Function Description87
File Operation89
Save/Recall90
Restore Factory Default Settings93
System Settings94
System Information95
System Settings96
Firmware Upgrading98
Description of Using Flash Drive99
Remote Control101
Connection Usage103
Usb106
Gpib108
Lan110
Command Syntax116
Command List120
Measurement Instructions120
Display Functions120
Output Commands120
Source and Load Commands121
Status Commands126
System Commands127
System Related Commands128
IEEE488.2 Common Commands129
Command Details130
Measurement Commands130
Display Commands132
Output Commands134
Source and Load Commands139
Status Commands183
System Commands190
System Related Commands199
SCPI Status Registers SCPI200
Event Registers202
Enable Registers202
Status Byte Register202
Standard Event Register204
Status Byte Register Commands205
Standard Event Register Commands206
Other Status Register Commands208
Errors209
Error Message209
Command Errors209
Appendix213
Replacing the Fuse213
Specifications214
Optional Accessories217

Brand	GW Instek
Model	GPP-3060
Category	Power Supply
Language	English

GW Instek GPP-3060 User Manual

Table of Contents

Questions and Answers:

GW Instek GPP-3060 Specifications

Related product manuals