REMOTE CONTROL
143
:OUTPut:PARallel ON
Sets CH1/CH2 as tracking parallel mode.
Selects the operation mode: independent, tracking
series, or tracking parallel. Series-parallel mode is
not supported under LOAD.
NR1 0: Independent, 1: Series, 2: Parallel
TRACK0
Selects the independent mode.
:LOAD[1|2]:CV {ON|OFF}[,FAST]
Sets CH1/CH2 as Load CV mode. Automatically
switch to power mode after closing LOAD mode.
[FAST]: In order to protect the function switching
device” relay”, it is necessary to wait until the
voltage and current drop to zero under normal
conditions. When FAST is enabled, this factor will
not be considered, but it is easy to damage the
“relay”, so it is recommended to use it with
caution.
:LOAD2:CV ON
Sets CH2 as Load CV mode.
:LOAD[1|2]:CC {ON|OFF}[,FAST]
Sets CH1/CH2 as Load CC mode.